View Full Version : not connect to Broker
jaffa123
11-30-2007, 10:43
Hello.
I installed Integration server and webBroker . But when I start up IS (cmd: server.bat -debug 6 -log none), I get this message error :
Not performing broker push (not connected)
(I checked in AdminisdtrativeTools/Services are Broker Monitor and Broker services running , ang it is ok- it is running).
How can I fix the problem?
You need to configure IS to connect to a Broker.
jaffa123
11-30-2007, 17:03
Can you be more specific, please? because I just start to learn and work in WM.
I followed instruction how to install and configure IS step by step , but when I come to the part when I must start up and configure IS , then I get that error.
mcarlson
11-30-2007, 18:48
You'll find the information you need in the IS Administrator's Guide. You really should spend lots of time with this document.
Search for "Configuring the Server to Connect to a Broker".
The message you see is merely informational. When you start IS you'll see this message until you configure the connection to the Broker. Continue with the instructions from the guide as Mark described and you'll be fine.
ivasiwala
12-10-2007, 00:33
Hi mate,
1. First connect to the IS as http://servername:port
2. In the navigation panel there is a Setting panel inside that Broker link
click on it
3. one window will pop up
4. click on edit broker setting click on the top of the page
5. Click on Configure option button and save the configuration
6. now restart the server
finish