View Full Version : How we can see the webMethods65 monitor
RaviKumar Anumolu
10-10-2005, 14:12
hello seniors,
now i am using the webMethods 6.5 ,i am not able to see my webmethods monitor using IS.
in IS-packages\management\ here when i am working for monitor it is not displaying the monitor functions,it is opening new window with monitor but no options on that.
if possible please clear to me this problem
griffima
10-10-2005, 14:23
The old monitor pre-6.5 is gone in the latest 6.5 release. It has been replaced by my webMethods Server. This was released about a week ago. You should see it as part of your download now. It actually installs a scaled down version of the portal product to give you access to monitor views.
markg
http://darth.homelinux.net
RaviKumar Anumolu
10-10-2005, 14:57
Hi mark,
Thank you very much for your fast reply,i did like that too even though i may not see the options in the monitor,when i referred that my webmethods document i found that option but it is not at useful me,may be i made a mistake,if possible can u give me the exact approach if possible.
i did in the following way:
http:\( xxxx):port\mywebmethods---
if it not correct can u give me the idea how will be the specification
Thanx once again
Ravi
griffima
10-10-2005, 16:01
Ravi,
The my webMethods Server is a separate install and server process. If you download it via the webMethods Installer and install, it will prompt you to configure the packaged portal server. Once you have it installed it, you can connect via http://yourhost:8080/ . It does not run inside the Integration Server JVM.
markg
http://darth.homelinux.net
RaviKumar Anumolu
10-10-2005, 17:47
Hi Mark,
I installed my webmethods server as follows
1)through installer i selected the my WMServer and monitor and related to that.
in the following folder
(home)webmethods[ex:c:\webmethods]
2)i hope it is not compulsory to restart but any way i did that.
3)and i followed same steps what you specified before
Even though there is no response form my monitor.still i made any mistake or i have to follow any other extra steps
Thank you very much,
Sincerely
Ravi
griffima
10-12-2005, 10:00
Ravi,
The portal install should have brought up an installation screen where you configure the database and server listening port for the portal. The portal then attempts to start after that configuration. You will see whether it was successful or not via the installation screen. Check the 6.5 install guide on advantage (the latest one) which has the instructions for configuring the my webMethods Server.
markg
http://darth.homelinux.net