PDA

View Full Version : Siebel adapter config problem

prajno
10-12-2004, 00:57
I am trying to configure the Siebel Adapter6.0 in the IS6.1. The parameters, which I have given to configure the Siebel Adapter, are correct. But when i try to enable the connection i am getting the following error:
"threw a SiebelException: code(4102), msg(Could not open a session in 4 attempts. {1}"
I am trying to connect to Siebel 7.5.3.
Any one even faced this issue before?
saravanan
10-12-2004, 07:35
Hi,

IS 6.1 is having some problem. you need to apply patch for the same.

regards,
Saravanan.E
prajno
10-12-2004, 21:30
I have resolved this problem, thx!
ashok_bohra
10-13-2004, 03:14
prajno,

If you do not mind, can you post the solution also. So that anyone searching the form next time for same problem, is not disappointed by not finding the solution in here.

Regards
Ashok
ashok_bohra
10-13-2004, 03:14
prajno,

If you do not mind, can you post the solution also. So that anyone searching the forum next time for same problem, is not disappointed by not finding the solution in here.

Regards
Ashok